Troubleshooting / Failure diagnosis

• ●A picture is too bright. / A picture is too dark.

• •It may be overexposure in a setting. If the exposure compensation is configured to plus [+], change the setting to [0.0].
• •It may be set a long exposure time (Time exposure). Test after changing the Time exposure OFF.
• •Amount of light may not be appropriate. If you use a flash, adjust a light amount to a subject such as ;
  • ○walk away from a subject
  • ○turn a flash OFF and then contrive ways to make the subject more in other light.
• •Check if the brightness of the LCD is appropriate.
• •Check if it is sure to focus on the subject before pressing the shutter release. With being out of focus, if you take a picture with a flash and the suject is so close, there may be a case that an image is too bright. Also see the topic below.

FAQ No. EDCR06023 [A captured image is out of focus. / It looks like blurred.]

• •Check to see if there is some dew condensation on the glass in front of the lens.

• •If you set [Flash OFF] in the flash mode, change it to other modes.
• •It may be underexposure in a setting. If the exposure compensation is configured to minus [-], change the setting to [0.0].
• •It may be out of the range that a flash light reaches. Consult your operating manual for the flash range.