• Brand
  • Products
  • Store
  • Community
  • Support

Support & Service

FAQ


PENTAX Tethered Capture Plug-in for Adobe® Photoshop® Lightroom® via IMAGE Transmitter 2

Below is a list of frequently asked questions and corresponding answers for PENTAX Tethered Capture Plug-in for Adobe® Photoshop® Lightroom® via IMAGE Transmitter 2.


Which OS are corresponded?


It is corresponded following OS
Windows --- Windows 10 (32bit/64bit) / Windows 8.1 (32bit/64bit) / Windows 8 (32bit/64bit) / Windows 7 (32bit/64bit) Required to install NET Framework 4.5.1 or later version

Mac OS --- macOS v10.13 High Sierra / macOS v10.12 Sierra / macOS v10.11 El Capitan /macOS v10.10 Yosemite
Which version of Adobe® Photoshop® Lightroom® is corresponded?


It is the Adobe® Photoshop® Lightroom® 6 / Classic CC
How to control the camera with the Tethered capturing?


It is controlled by the PENTAX IMAGE Transmitter 2.You cannot use the functions such as the Shutter button of the Adobe® PhotoShop® Lightroom®.
You are required to install the PENTAX IMAGE Transmitter 2 Version 2.2.1 or later beforehand.
How to confirm the version of the Plug-in?


It will be displayed if the PENTAX Tethered plug-in is selected at the Plug-in manager of the File of the Adobe® Photoshop® Lightroom®
How to operate the Tether capturing only using by the Adobe® PhotoShop® Lightroom®.


It is possible if you use the PENTAX Tethered Capture Plug-in for Adobe® Photoshop® Lightroom®(Simple Version).
In case of both plug-in are installed, below two plug-in are displayed at the Plug-in manager of the Adobe® Photoshop® Lightroom®
 (1) ”PENTAX Tether Plugin“
 (2) ”PENTAX Tether Plugin IT2 “
If you set (1) to enable, then you can operate Tether capturing by the Adobe® PhotoShop®Lightroom® alone.
However, you cannot use both plug-in at the same time.
Can the captured image be stored for Image Transmitter 2 ?


No. The captured image file that stored once in the folder of Image Transmitter 2 will be take in to the Adobe® Photoshop® Lightroom®. The Lightroom® changes the name of folder for its own control and move into the Lightroom®, therefore the captured image will not be stored into the Image Transmitter 2.
In case of I set the [Memory card setting] to [Save to both](Saves the same data to the memory cards in both the SD1 and the SD2 slots),
sometime I cannot forward image, why?


The image stored function of the Adobe® Photoshop® Lightroom® is transfer the original image file from the folder of Image Transmitter 2, therefore the name of 2nd reproduced file may happen to be same as 1st one, result of this some image file may not be stored in the Lightroom®.
Please set the [Memory card setting] to other than [Save to both] when you use this plug-in software.
Back to Top

Page top