G700 FAQs - By Product
[Question] How to set / authenticate a password (camera lock - Barcode)
Password is used to set the [Password Protection] function, or to change or release the limit for camera operations.The password setting is located in the Setup menu.
[About the Setup menu operations.]
Use the following procedure for setting and authentication with barcode.
[Choose/Change password]
- 1Go to Setup menu, then choose [Choose/Change Password].
-
- 2Choose [Barcode] in the screen below, and click [OK].
-
- 3[Read Barcode] screen is displayed.
-
Like the figure above, point the camera to make the barcode into the blue frame. Press the [MENU/OK] button.
If you want to cancel it, press the [DISP.] button. -
4The camera reads the barcode. After succeeding the password reading, the password has been set. It returns to the menu screen.
If barcode reading fails; such as the camera cannot focus on the barcode, or the barcode is out of the blue frame; the message like below will be displayed. -
Choose [Yes] and press the [MENU/OK] button. It returns to the [Read Barcode] screen, then try again with the step 3.
• | [Supported Bar Codes] | ||
|
Example of supported barcodes.
[Password authentication]
- 1You will be asked when the password authentication is required.
-
Point the camera to make the barcode into the blue frame. Press the [MENU/OK] button. - 2If the authentication fails, you will be asked again as follows.
-
Choose [Yes] and press the [MENU/OK] button. It returns to the [Read Barcode] authentication, then point the camera to make the configured barcode into the blue frame, then press the [MENU/OK] button.
[How to set a limit to camera usage (camera lock).]
Date created:September 24, 2010
Date modified:September 28, 2010
Product:G700
Operating system: --
Category:Hardware specifications, Hardware operations
Do you need other information? Please click any link you want from the following.